Displaying items by tag: nuts

November 1, 2018 - PEM® self-clinching SH™ nuts and HFLH™ studs from PennEngineering® can successfully install in high-strength thin steel sheets to provide permanent threads for mating hardware in automotive component attachment applications. These hard panel nuts and studs manufactured from hardened alloy steel ultimately exhibit stronger thread strength compared with conventional fasteners. The fasteners additionally eliminate the environmental-related issues typically associated with alternative thin-sheet fastening devices.

Due to a lightweight design and reduced need for loose hardware such as washers, these fasteners can contribute to overall weight reductions in vehicle assemblies. Lower installed cost can be gained from the elimination of embossing operations and the capability to install automatically using a standard press or in-die technology. Small outer diameters of the fasteners enable close-to-edge mounting without risking sheet buckling and, upon installation, the reverse side of the host sheet will remain flush and unmarred for a clean appearance.

PEM SH nuts are engineered to install into high-strength steel sheets at 975MPa maximum ultimate tensile and as hard as HRC 30 or less on the Rockwell “C” scale. Host panels can be as thin as 1.4 mm / .056 in. Standard thread sizes are M6, M8, and M10 for metric nuts and ¼-20, 5/16-18, and 3/8-16 for unified versions.

PEM HFLH studs will install successfully into high-strength steel sheets at 700MPa maximum ultimate tensile and as hard as HRB 91 or less on the Brinell scale. Host panels can be as thin as 1mm / .040 in. Standard thread sizes are M5, M6, and M8 for metric studs and #10-32, ¼-20, and 5/16-18 for unified versions.

August 14, 2018 - PEM SFN spinning flare nuts from PennEngineering become permanently captivated upon installation in thin metal sheets and, when paired with a self-clinching stud or other fixed externally threaded hardware, can eliminate all loose fasteners (including flange nuts) in attachment applications. These one-piece, flanged hex nuts additionally will spin freely in a sheet enabling quick attachment to mating hardware. Their use ultimately promotes savings in assembly time and costs.

PEM SFN steel spinning flare nuts install in steel, stainless steel, or aluminum sheets of any hardness and as thin as 1mm. They are available in metric thread sizes M5, M6, and 8.

Permanent installation is accomplished by inserting the nut into a properly sized, pre-punched, and embossed mounting hole in a metal sheet and then applying sufficient squeezing force to flare the fastener’s shank. When installed, the part will appear identical to a standard flanged hex nut above the sheet and will remain flush on the other side.

PennEngineering
Danboro, Pennsylvania
800/237-4736

PemHex self-clinching prevailing torque locknuts have a blue nylon hexagonal insert designed to prevent mating screws from loosening. The reusable locking element provides the necessary torque resistance to securely grip mating screws and allow for their repeated installation and removal over time. These PL steel and PLC stainless steel locknuts install permanently in thin steel or aluminum sheets.

PennEngineering
Danboro, Pennsylvania
800/237-4736
www.pemnet.com